Service Guide

Intel

Server System SR1600UR Service Guide 41

Removing and Installing the PCI Riser Assembly

Removing the PCI Riser Assembly

To remove the PCI riser assembly, follow these steps:

1. Disconnect any cables attached to any add-in cards.

2. Grasp both riser latches with thumb and forefinger (see letter “A” in Figure 26),

and pull up to release riser assembly.

3. Lift riser assembly straight up (see letter “B” in Figure 26).

Figure 26. Removing PCI Riser Assembly from the Server System

Caution: Place the riser assembly upside down to avoid damage to the riser card connector.

4. Do one of the following:

— If you need to add or replace a PCI add-in card, see “Installing and Removing a

PCI Add-in Card” on page 44.

— If you need to add or replace a PCI riser connector, see “Replacing a PCI Riser

Card” on page 43.

Riser Card

Connector

AF002894