Service Guide

Intel
®
Server System SR2600UR/SR2625UR Service Guide 71
Figure 54. Installing the Large Air Baffle
Installing and Removing a Hot-swap Hard Drive (Intel
®
Server System SR2600UR only)
In the Intel
®
Server System SR2600UR, you can install up to six hot-swap SAS or SATA
drives.
Cautions: If you install less than six drives or devices, empty drive bays must be occupied by
carriers with baffles to maintain proper system cooling.
To avoid possible damage to your server system, do not use older style drive carriers.
Note: The server system does not support all hard drives. For a web link to a list of supported
hard drives, see “Additional Information and Software” on page 4.
Installing a SAS or SATA Hot-swap Hard Disk Drive
To install a SAS or SATA hot-swap hard disk drive in Intel
®
Server System SR2600UR,
follow these steps:
1. Press the green latch towards the black lever and pull out on the lever to release the
hard drive carrier (see letter "A" in Figure 55).
2. Slide the carrier from the server system (see letter "B" in Figure 55).
AF002961