Service Guide

Intel

Server System SR2600UR/SR2625UR Service Guide 109

Installing the Backplane

To install the backplane, follow these steps:

1. Remove the midplane board. For instructions, see “Removing the Midplane Board”

on page 103.

2. Remove all hot-swap drive carriers, regardless of whether or not a drive is installed

in the carrier. For instructions, see “Removing a SAS or SATA Hot-swap Hard Disk

Drive” on page 74.

3. Depending on your server system, do one of the following:

For Intel

Server System SR2600UR, do the following:

a. Hold the backplane only by the edges. Do not push or pull on any components on

the backplane. Set the backplane in place at the front of the server system, with

the sides of the board resting in the guides at the left and right sides of the server

system.

b. Slide the backplane into the server system guides at the left and right sides of the

server system until the pins at the left and right sides of the backplane bracket are

fully inserted into the matching holes in the server system (see letters “A” and

“B” in Figure 103).

Figure 103. Installing the Backplane into the Intel

Server System SR2600UR

For Intel

Server System SR2625UR, do the following:

a. Hold the backplane only by the edges. Do not push or pull on any components on

the backplane. Set the backplane in place at the front of the server system (see

letter “A” in Figure 104).

AF002975