Service Guide

Intel
®
Server System SR2600UR/SR2625UR Service Guide 103
a. Open the bridge board connector retention clips on the midplane and the server
board (see letter “A” in Figure 96).
b. Disconnect the bridge board from the connector on the midplane and server
board and lift the bridge board straight up (see letter “B” in Figure 96).
c. Slide the board out of the fan assembly (see letter “C” in Figure 96).
Figure 96. Removing the Bridge Board from the Server System
6. Remove the fan module. For instructions, see “Replacing a Fan Module” on
page 128.
7. Hold the midplane board only by the edges and slide the midplane board in the
direction shown to release it from the backplane (see letter “A” in Figure 97).
AF002971
A
B
C