Service Guide

Intel
®
Server System SR2600UR/SR2625UR Service Guide 101
Removing the Intel
®
RMM3
To remove the Intel
®
Remote Management Module 3, follow these steps:
1. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” on page 50.
2. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” on page 56.
3. Remove screws from the back of the chassis (see letter “A” in Figure 94).
4. Disconnect the Intel
®
RMM3 from the connector on the server board (see letter “B”
in Figure 94) and remove the module out of the server system (see letter “C” in
Figure 94).
Figure 94. Removing Intel
®
RMM3 from the Server System
B
A
RMM3
Connector
RMM3 Module
AF003010
C