Service Guide

Intel

Server System SR2600UR/SR2625UR Service Guide 89

b. Install one end of the short SATA cable to the SATA connector on the backplane.

c. Install the other end of the short SATA cable to the SATA connector on the sixth

HDD board (see letter “B” in Figure 79).

d. Proceed to step 5.

Figure 79. Installing Power and SATA Cables (Active Midplane Installed)

Note: You will not use the long SATA cable from the 6th HDD kit in a system with an active

midplane.

If you have a passive midplane installed in your system, do the following:

a. Install one end of the power cable to the power connector on the backplane and

the opposite end to the power connector on the sixth HDD board (see letter “A”

in Figure 80).

b. Install one end of the long SATA cable (labeled HSBP/TAPE) to the sixth HDD

board (see letter “B” in Figure 80) and route the cable through the air baffle (see

letter “C” in Figure 80).

c. Connect the other end of the cable (labeled SERVER BOARD) to the SATA5

connector on the server board (see letter “D” in Figure 80).

AF003033