Service Guide

Hardware Installations and Upgrades
56 Intel® Workstation System SC5650SCWS Service Guide
14. Re-attach the drive cage EMI shield to the chassis and tighten the thumb screw.
Figure 58. Re-installing Drive Cage EMI Shield
15. Re-install any PCI add-in cards that were removed. For instructions, see “Installing PCI
Add-in Boards”.
16. Re-install the front bezel assembly. For instructions, see “Installing the Front Bezel
Assembly”.
17. Re-install the left side cover. For instructions, see “Installing the Left Side Cover”.
18. Plug all peripheral devices and the AC power cable back into the workstation. Power up
the workstation.
Removing a Fixed Hard Drive
CAUTION
Fixed drives are NOT hot-swappable. Before removing or replacing the drive, you
must first take the workstation out of service, turn off all peripheral devices connected
to the system, turn off the system by pressing the power button, and unplug the AC
power cord from the system or wall outlet.
1. Observe the safety and ESD precautions listed in Appendix A, “Safety Information”.
2. Power down the workstation and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see “Removing the Left Side Cover”.
4. Remove the front bezel assembly. For instructions, see “Removing and Installing the Front
Bezel Assembly”.
5. Loosen thumb screw (see letter “A” in the following figure). Apply slight pressure to the
right side of drive bay access door and swing door outward (see letter “B”).