Service Guide

Hardware Installations and Upgrades
Intel® Workstation System SC5650SCWS Service Guide 47
board in your equipment log. Set jumpers or switches on the board according to the manufacturer’s
instructions.
7. Hold the PCI add-in board by its top edge or upper corners. Firmly press the add-in board into an expansion
slot on the workstation board (see letter “A” in the following figure). Close the back panel PCI Add-in Card
Retention Device (see letter “B”).
Figure 42. Installing PCI Add-in Card
8. Repeat the previous steps until all PCI add-in boards are installed.
9. Attach cables, if necessary.
10. Reinstall the left side cover. For instructions, see “Installing the Left Side Cover”.
11. Reconnect all peripheral devices and the AC power cable. Power up the Workstation.
Removing PCI Add-in Cards
CAUTIONS
PCI add-in boards can be extremely sensitive to electric static discharge (ESD) and always require careful
handling. After removing the add-in board from its protective wrapper or from the workstation board, place it
component side up on a grounded, static-free surface or conductive foam pad. Do not slide the add-in board
over any surface.
1. Observe the safety and ESD precautions listed in Appendix A, “Safety Information”.
2. Power down the workstation and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see “Removing the Left Side Cover”
4. Open the back panel PCI Add-in Card Retention Device by pressing open from the inside of the chassis.