Service Guide

Hardware Installations and Upgrades
Intel® Workstation System SC5650SCWS Service Guide 43
4. Remove the front bezel assembly. For instructions, see “Removing the Front Bezel Assembly”.
5. Remove the EMI shield from the 5.25-in device drive bay (see letter “A” in the following figure). Move
latch to the “unlock” position (see letter “B”).
Figure 35. Removing 5.25-inch drive EMI Shield
6. Insert the CD-ROM or DVD-ROM drive into the 5.25-in device drive bay (see letter “C” in the following
figure). Line up holes in CD-ROM drive with holes in chassis (see letter “D”). Move latch to the “lock”
position (see letter “E”). Connect power (P5 or P6connector from the power supply. An additional 4-
pin IDE male-to SATA 15-poin power cables adapter may be needed if the CD-ROM or DVD-ROM
does not have a 4-pin power connector.) and data cables to the rear of the CD-ROM or DVD-ROM
drive (see letter “F”).
Figure 36. Installing CD-ROM or DVD-ROM Drive (SATA Optical Drive is shown)
7. If necessary, remove the filler panel from the front bezel assembly.