Service Guide

Hardware Installations and Upgrades
Intel® Workstation System SC5650SCWS Service Guide 37
Figure 26 .Installing Memory
5. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open position (Step
“A” )
6. Holding the DIMM by the edges, remove it from its anti-static package.
7. Position the DIMM above the socket. Align the small notch in the bottom edge of the DIMM with the key in
the socket (Step “B” )
8. Insert the bottom edge of the DIMM into the socket (Step “C”)
9. When the DIMM is inserted, push down on the top edge of the DIMM until the retaining clips snap into
place (Step “D”)
10. Visually check that each latch is fully closed and correctly engaged with each DIMM edge slot (Step “E”)
11. Replace the workstation’s cover and reconnect the AC power cord.
Removing DIMMs
To remove a DIMM, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this book. For more information, see Safety
Information.
2. Turn off all peripheral devices connected to the workstation, and turn off the workstation.
3. Remove the AC power cord from the workstation.
4. Remove the workstation’s cover and fan duct.
5. Gently spread the retaining clips at each end of the socket. The DIMM lifts from the socket.
6. Holding the DIMM by the edges, lift it from the socket, and store it in an anti-static package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the DIMM sockets.
8. Replace the workstation’s cover and reconnect the AC power cord.
Installing or Replacing the Processor
/
NOTE
Use the following instructions to install or replace a processor instead of using the
instructions that came with the processor.