Service Guide

Hardware Installations and Upgrades
36 Intel® Workstation System SC5650SCWS Service Guide
Figure 25. Installing System Fan Duct
Installing and Removing Memory
The silkscreen on the Intel
®
Workstation System Workstation board for the DDR3 DIMM sockets displays
DIMM_A1, DIMM_A2, DIMM_B1, DIMM_B2, DIMM_C1, DIMM_C2, DIMM_D1, DIMM_D2, DIMM_E1,
DIMM_E2, DIMM_F1, and DIMM_F2, starting from the inside of the board. See “Memory” for a discussion on
memory installation rules, requirements, and options. See “Additional Information and Software”
.
Installing DIMMs
To install DIMMs, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this book. For more information, see Safety
Information.
2. Turn off all peripheral devices connected to the workstation and turn off the workstation.
3. Disconnect the AC power cord from the workstation.
4. Remove the workstation’s cover and fan duct, and locate the DIMM sockets. See “Memory”.