Service Guide

System Utilities
28 Intel® Workstation System SC5650SCWS Service Guide
8. Startup.nsh file will execute automatically and initiate the BIOS update with the recovery BIOS capsule
file. Once the recovery process is complete, the message, “BIOS has been updated successfully”
displays.
9. Power off the system and revert the BIOS recovery jumper position to default (pin 1-2).
10. Power on the system.
CAUTION
DO NOT interrupt the BIOS POST during the first boot after recovery!
Clearing the Password
If the user or administrator password(s) is lost or forgotten, moving the password clear jumper into the “clear”
position clears both passwords. Before setting a new password(s), you must restore the password clear
jumper to its original position. The password clear jumper is located on jumper block J1E4.
1. Power down the workstation. Do not disconnect the power cord.
2. Open the chassis. For instructions, see your workstation chassis documentation.
3. Move the jumper (J1E4) from the default operating position, covering pins 1 and 2, to the password
clear position, covering pins 2 and 3.
Figure 16. Password Clear Jumper
4. Close the workstation chassis.
5. Power up the workstation and then press <F2> to enter the BIOS menu to check if the password is
cleared.
6. Power down the workstation.
7. Open the chassis and move the jumper back to its default position, covering pins 1 and 2.
8. Close the workstation chassis.
9. Power up the workstation.
The password is now cleared and you can reset it by going into the BIOS setup.