Service Guide

Workstation System Features
8 Intel® Workstation System SC5650SCWS Service Guide
Callout Button/LED Name Color Condition Description
and voltage, and so forth
Off
Off AC Power off;
Off
Powered Down (DC-off state or S5), and no
degraded, non-critical, critical conditions
exist*
* When the workstation is powered down (transitions to the DC-off state or S5), the BMC is still on standby
power and retains the sensor and front panel status LED state established before the power-down event. If the
system status is normal when the system is powered down (the LED is in a solid green state), the system
status LED will be off.
Figure 6. Front Panel Components
Mechanical Locks
The Intel
®
Workstation System SC5650SCWS chassis support the installation of a padlock loop (see letter “A”
in the following figure) at the rear of the chassis. Additionally, the system ships with a two-position mechanical
lock (see letter “B”) on the front bezel assembly to prevent access to the hard drives and the interior of the
system.
Figure 7. Mechanical Locks
Peripheral Devices
The Intel
®
Workstation System SC5650SCWS provides locations and hardware for installing hard dives, a
floppy drive, CD-ROM driver, DVD-ROM drive, or tape drive. You must purchase the drives separately.
/
NOTE
It is recommended that screws be used to secure large devices if shipping system integrated.
Hard Disk Drives
The Intel
®
Workstation System SC5650SCWS ships with fixed hard disk cage capable of supporting up to six
3.5-inch hard drives at 3GB/s. Power requirements for each individual hard drive may limit the maximum
number of drives that can be integrated into the workstation system. For instructions on installing hard drives,
see “Installing and Removing a Fixed Hard Drive”.