Service Guide

Workstation System Features
2 Intel® Workstation System SC5650SCWS Service Guide
Feature Description
 One 92-mm system fans (Hard Disk Cage fan)
 Active processor heat sink(s) is required
Processors
 Up to two Intel
®
Xeon
®
Processors 5500 series with Thermal Design Power
(TDP) up to 130 W
 Up to two Intel
®
Xeon
®
Processors 5600 series with Thermal Design Power
(TDP) up to 130 W
Memory
 Six memory channels (three channels per processor socket) with support for
800/1066/1333 MT/s ECC Registered (RDIMM) or ECC Unbuffered (UDIMM)
DDR3 memory
 12 DIMM sockets, two DIMM sockets per channel
 No mixing of RDIMMs and UDIMMs
 Mixing memory type, size, speed, and/or rank on this platform has not been
validated and is not supported
 Mixing memory vendors is not supported on this platform by Intel
 Non-ECC memory is not supported and has not been validated in a
workstation environment
Chipset
 Intel
®
S5520 Chipset and Intel
®
82801Jx I/O Controller Hub (ICH10R)
Add-in card slots
 Two PCI Express* Gen 2 x16 slots
 One PCI Express* Gen 1 slot (x4 mechanically, x1 electrically)
 One PCI Express* Gen 1 slot (x8 mechanically, x4 electrically) shared with
SAS Module Slot. This PCI Express* Gen 1 slot is not available when the
SAS module slot is in use and vice versa
 One 32-bit/33MHz PCI slot, keying for 5-V and universal PCI add-in card
Video Support
 WorkstationEngines* LLC Pilot II* with 64 MB DDR2 memory, 8 MB allocated
to graphics
 Dual video is supported
 On-board video available with optional accessory cable (FXXSCVDCBL)
 Support add-in PCI Express* graphics cards
o Single graphics card configuration at PCI Express* slot 6 with
graphics card up to 300W
o Dual graphics cards conifiguration at PCI Express* slot 4 and slot 6
with each graphics card up to 150W
o Keep PCI Express* Slot 3 empty for optimal air flow when
populating a graphics card in PCI Express* slot 4.
o Graphics cards with power greater than 75W must be self-cooled
with exhaust out the back of the chassis
USB drive support
 One internal USB port
 One internal low-profile USB port for Solid State Drive
I/O control support
 External connections:
o RJ-45 serial port A connection
o One 7.1 channel Audio connector
o One 1394 connector for IEEE1394a support
o One DH 10 serial port connector (optional)
o Two RJ-45 NIC connectors for 10/100/1000 Mb connections: Dual
GbE through the Intel
®
82575EB Network Connection, with Intel
®
I/O Acceleration Technology 2 support
o Four USB 2.0 ports at the back of the board
 Internal connections:
o Two 9-pin USB headers, each supports two USB 2.0 ports
o
One internal USB port that supports a peripheral, such as a floppy