Technical Product Specification

Cooling Sub-System Intel® Server System SR1695WB TPS

Revision 1.4

Intel order number: E92079-005

Each memory fan (Group A) uses 8-pin connector, which is connected to fan connector on

mother board (Connector BB and Q in Figure 5).

Each processor fan (Group B) uses 4-pin connector, which is connected to processor fan

connector on mother board (Connector S, T and Y, Z in Figure 5).

The fan connector pin-out definition is as follows:

Table 28. 4-pin Connector Pin-Out for Processor Cooling Fan

Pin Signal Name Description

1 GND Ground

2 12V Power Supply +12 V

3 Tach Out FAN_TACH signal output

4 PWM In PWM signal input

Table 29. 8-pin Connector Pin-Out for Memory Cooling Fan

Pin Signal Name Description

1 GND Ground

2 12V Power Supply 12 V

3 Tack0 Tach signal output from FAN0

4 PMW0 PWM control signal input for FAN0

5 GND Ground

6 12V Power Supply 12 V

7 Tach1 Tach signal output from FAN1

8 PWM1 PWM control signal input for FAN1

4.3 Power Supply Fan

Each power supply module supports one non-redundant 40 mm fan. The fans control the

cooling of the power supply and some drive bays. These fans are not replaceable.

Therefore, if a power supply fan fails, you must replace the power supply module.

4.4

Air Duct Module

The chassis requires the use of an air duct module to direct airflow over critical areas within

the system. The following provides a summary and description of Air Duct Module.

Figure 16. Air Duct Module