Specifications

System Service
Intel
®
Server System SR1670HV Service Guide 33
Figure 55. Aligning the Module with the Alignment Slots on the Chassis
17. Slide the hard drive bay module back until the screw holes are aligned.
18. Secure the HDD bay module to the chassis using the six screws, three on each
side.
19. Install the hard drives into the same position from which they were removed.
4.4 Front Control Panel Replacement
The system includes two separate control panels (one for each server node) on the front
of the chassis which are mounted onto a single removable module. In the event a control
panel’s features stop functioning and it is determined it should be replaced with a spare,
you must perform the following procedure.
1. Power down both server modules and remove AC power.
2. Remove the single screw holding the Control Panel Module in place.
Figure 56. Control Panel Module Screw
3. Carefully pull back the Control Panel module until the cables are fully exposed and
accessible.