Specifications

Hardware Setup
Intel
®
Server System SR1670HV Service Guide 15
Figure 19. Removing the Heatsink
NOTE: Tighten the four heatsink screws in a diagonal sequence.
2.3 System Memory
2.3.1 Overview
Each installed server node supports twelve (12) DDR3 DIMM sockets—six for each
installed processor.
NOTE: You should only install memory in DIMM sockets DIMM_D1 through DIMM_F2 when
dual processors are installed on a given server node. On a given server node, DIMM sockets
DIMM_D1 through DIMM_F2 are not enabled in single processor configurations.
The following figure illustrates the location of the DDR3 DIMM sockets.