Product Service Guide

46 Intel
®
Server System SR1630BC Service Guide
Figure 40. Installing the PCI Riser Assembly
3. Press down uniformly until the two hooks on the rear of the PCI riser assembly
engage the server system back panel slots. The riser card will seat into the matching
socket on the server board. Ensure the riser card is fully seated.
Installing and Removing a PCI Add-In Card
The following instructions describe how to install and remove a PCI add-in card.
Installing a PCI Add-In Card
Peripherals and add-in cards are not included in your system. You must purchase them
separately. The riser card at the PCI slot 6 of the chassis supports a low-profile half-length
PCI Express* 2.0 x8 add-in card.
1. After removing the PCI riser assembly from the server system, remove the screw
that attaches the PCI bracket shield to the rear of the chassis to remove the shield.
Retain the screw.
2. Insert the PCI card edge connector in the slot on the PCI riser.