Product Service Guide

Hardware Installations and Upgrades

28 Intel® Server System SC5650BCDP Service Guide

Installing the Front Bezel Assembly

1. Line up the three clips on the right side of the front bezel assembly with the

corresponding slots on the right side of the chassis (see letter “A” in the following

figure). Engage the clips with the slots (see letter “B”). Rotate the left side of the front

bezel assembly towards the chassis (see letter “C”). Snap the two bezel tabs into the

corresponding recesses at the left edge of the chassis front panel (see letter “D”).

Figure 20. Installing the Front Bezel Assembly

2. Reinstall the left side cover. For instructions, see “Installing the Left Side Cover”.

3. Reconnect all peripheral devices and the AC power cable. Power up the server.

Installing and Removing Memory

The silkscreen on the board for the DIMMs displays DIMM_A1, DIMM_A2, DIMM_B1,

and DIMM_B2, DIMM_D1, DIMM_D2, DIMM_E1, DIMM_E2 starting from the inside

of the board. DIMM_A1 is the socket in blue closest to the processor 1 socket. For two

slots per channel configurations, the server board requires DDR3 DIMMs within a

channel to be populated starting with the DIMM farthest from the processor. The DIMM

farthest from the processor per channel is blue on the board.

Installing DIMMs

To install DIMMs, follow these steps:

1. Observe the safety and ESD precautions at the beginning of this book. See “Safety

Information” for more information.

TP02035