Service Guide

Intel

Server System SR1560SF Service Guide 47

Installing the Fan Board

1. Lower the fan board into the system (see letter “A”) and position the fan board over

the retention pins as shown.

2. Slide the fan board to the left (see letter “B”) to lock it in place and install the screw

(see letter “C”).

3. Connect power to the fan board power connector (see letter “D”).

Figure 53. Installing the Fan Board into the Server System

4. Connect fan cables to the fan board.

Replacing the Server Board

Removing the Server Board

1. Remove CPU air duct and blue air baffle.

2. If installed, remove memory, processor heat sinks, and processors from the server

board.

3. If installed, remove bridge board (hot-swap systems only).

4. If installed, remove the PCI riser assembly.

5. If installed, disconnect all SATA cables from the server board.

AF002350