Service Guide

42 Intel

Server System SR1560SF Service Guide

Installing and Removing the Intel

Remote

Management Module 2 and the Intel

RMM 2 NIC

Installing the Intel

RMM2 and Intel

RMM2 NIC

1. Squeeze the sides of the Intel

RMM2 NIC module cover to disengage it from the

server system back panel and remove it.

2. Attach the foam gasket to the bottom of the Intel

RMM2 NIC module (see letter

“A”).

Note: The Intel

RMM2 NIC module is shown upside down in the first illustration below in

order to provide better detail on installing the foam gasket.

3. Attach the standoffs to the server board (see letter “B” in the figure below) and

attach the Intel

RMM2 NIC module to the server board (see letter “C”).

4. Insert the standoff into the hole labeled TH4 on the Intel

RMM2 board (see letter

“D” in the figure below). The standoff installs on the bottom side of the Intel

RMM2 board.

5. Attach the Intel

RMM2 board to the server board connector and snap the standoff

into the matching hole on the server board (see letter “E” in the figure below).

Figure 46. Installing the Intel

RMM2 and the Intel

RMM2 NIC Module to the

Server System

AF002378