Service Guide

32 Intel

Server System SR1560SF Service Guide

Installing and Removing a Hot-swap Hard Drive

Up to three hot-swap SAS or SATA drives can be installed in the Intel

Server System

SR1560SF - product code SR1560SFHS.

Cautions: If you install less than three drives or devices, the empty drive bays must be occupied by

carriers with drive blanks to maintain proper system cooling.

To avoid possible damage to your server system, use only the drive carriers that came

with your system.

Note: See “Server System References“ for an Internet link to a list of supported hardware.

Installing a SAS or SATA Hot-swap Hard Disk Drive

1. Open the latch at the front of the hard drive carrier (see letter “A”).

2. Pull out on the black lever and slide the carrier from the server system (see letter

“B”).

Figure 29. Removing Hot-swap Disk Carrier from the Server System

3. Remove the four screws that attach the plastic retention device or the previously

installed hard drive to the drive carrier (see letter “A”). Two screws are at each side

of the retention device or the hard drive. Remove the drive blank (see letter “B”)

and store it for future use.

Figure 30. Removing Drive Blank from Drive Carrier

TP02206

TP02207