Product User Guide

Contents
iv
Safety Information
WARNING
Before working with your Intel
®
RMM2 product, whether you are using this guide or any other
resource as a reference, pay close attention to the safety instructions. You must adhere to the
assembly instructions in this guide to ensure and maintain compliance with existing product
certifications and approvals. Use only the described, regulated components specified in this
guide. Use of other products / components will void the UL listing and other regulatory
approvals of the product and will most likely result in noncompliance with product regulations in
the region(s) in which the product is sold.
WARNINGS
System power on/off: The server power button DOES NOT turn off
the system power or Intel
®
RMM2 power. To remove power from the
Intel
®
RMM2 you must unplug the server AC power cord from the wall
outlet. Make sure the AC power cord is unplugged before you open
the chassis to add or remove the Intel
®
RMM2.
Hazardous conditions, devices and cables: Hazardous electrical
conditions may be present on power, telephone, and communication
cables. Turn off the server and disconnect the power cord,
telecommunications systems, networks, and modems attached to the
server before opening it. Otherwise, personal injury or equipment
damage can result.
Electrostatic discharge (ESD) and ESD protection: ESD can
damage disk drives, boards, and other parts. We recommend that
you perform all procedures in this chapter only at an ESD workstation.
If one is not available, provide some ESD protection by wearing an
antistatic wrist strap attached to chassis ground⎯any unpainted metal
surface⎯on your server when handling parts.
ESD and handling boards: Always handle boards carefully. They
can be extremely sensitive to ESD. Hold boards only by their edges.
After removing a board from its protective wrapper or from the server,
place the board component side up on a grounded, static free surface.
Use a conductive foam pad if available but not the board wrapper. Do
not slide board over any surface.
Installing or removing jumpers: A jumper is a small plastic
encased conductor that slips over two jumper pins. Some jumpers
have a small tab on top that you can grip with your fingertips or with a
pair of fine needle nosed pliers. If your jumpers do not have such a
tab, take care when using needle nosed pliers to remove or install a
jumper; grip the narrow sides of the jumper with the pliers, never the
wide sides. Gripping the wide sides can damage the contacts inside
the jumper, causing intermittent problems with the function controlled
by that jumper. Take care to grip with, but not squeeze, the pliers or
other tool you use to remove a jumper, or you may bend or break the
pins on the board.