User Guide

38 Intel
®
Remote Management Module User’s Guide
LAN/INTERFACE_SELECT Chooses and enables the
interface that will be used by
the Intel
®
RMM to send and
receive management traffic.
Read-write The default is selected via a
policy based on detected
hardware. The Intel
®
RMM will
determine if IPMI management
is enabled on the Intel
®
631xESB / 632xESB I/O
Controller Hub-embedded NIC
using IPMI commands. If only
LAN1 or LAN2 is enabled, then
that interface shall be used,
and the static/fixed setting in
place will be adopted by the
Intel
®
RMM.
If both LAN1 and LAN2 are
enabled, then LAN1 shall be
the default.
If neither LAN1 nor LAN2 are
enabled, then the Intel
®
RMM’s own NIC shall be
selected as the default when
the Intel
®
RMM is initially
installed.
LAN1 in the Intel
®
631xESB /
632xESB I/O Controller Hub is
the default.
LAN3/INTERFACE_TYPE Interface type for this LAN
interface.
Read-only Types:
• 0 = MM-MII
• 1 = MM-UMP-MII
• 2 = MM-RMII
• 3 = MM-UMP-RMII
• 4 = MM-DUAL-RMII
• 5 = MM-DUAL
• 6 = UMP_RMII
• 7 = Chipset-MII
• 8 = Baseboard-MII
• 9 = Chipset-FML
• 10 = TCO-FML
• 11 = Baseboard-FML
• 12-255 Reserved
Intel
®
631xESB / 632xESB I/O
Controller Hub systems will
only have:
• MM-MII
• Chipset-FML
LAN3/ADDR_TYPE IPv4 Read-only IPv4
Setting Name Description Type
Default Value (First in the
List) and (Format)