User Guide

Intel
®
Remote Management Module User’s Guide 43
SELF_TEST/CONTROL Initiate the self test when set
from 0 to 1. When test is
complete, the Intel
®
RMM
sets the flag from 1 to 0.
Writing a 0 has no effect.Set
SELF_TEST /
SUBCOMPONENT to
something other than 0
before setting this attribute to
1.
Read-write 0 = Test-Not-Running
1 = Initiate-Self-Test
1 = BUSY. (Same as test is
running).
SELF_TEST/STATUS Shows results of current or
last self test. If the test is
running then a 1 is returned.
Only the SELF_TEST/
SUBCOMPONENT attribute
is accurate, showing what
subcomponent is currently
executing in the self-test.If
the STATUS attribute is not 1,
then the test results are final.
A zero value means the test
passed. A non-zero value
means the test failed, in
which case the CONTROL
and REASON values are set.
Read-only 0 = Test complete; no errors.
1 = Test still running,
subcomponent field is valid.
2 = Test failed, unknown
cause, unknown component.
3 = Test failed with unknown
cause on known
subcomponent shown in the
subcomponent field.
4 = Test failed with identifiable
cause reflected in the “reason”
self test field in subcomponent
identified in the subcomponent
field.
SELF_TEST/LAN_MODE Sets the testing mode for the
LAN on the self test.
When set to 1, on systems
that support this function, the
self test will assume a valid
external connection on the
LAN, and hence Link testing
and a ping (ICMP) test to the
test peer address can be
performed.
Read-write 0 = No external wire testing.
(Test peer is not needed).
1 = External Peer connectivity
test shall be executed.
SELF_TEST/
LAN_PEER_ADDR_TYPE
Sets the IP version used in
the LAN ping test (ICMP).
Read-write 0 = IPv4
SELF_TEST/
LAN_PEER_ADDR
IP Address of another host to
ping. Address can be any
valid host computer, router or
gateway that supports ping.
Read-write IPv4 IP Address
Setting Name Description Type
Default Value (First in the
List) and (Format)