System Configuration User Guide

Channel_ID
IPMI Channel ID (this must be 4 for all supported server
boards).
2a
Authentication type for Callback privilege level.
Multiple privilege levels may be specified by using the
plus sign (see example below).
2b
Authentication type for User privilege level. Multiple
privilege levels may be specified by using the plus sign
(see example below).
2c
Authentication type for Operator privilege level.
Multiple privilege levels may be specified by using the
plus sign (see example below).
2d
Authentication type for Administrator privilege level.
Multiple privilege levels may be specified by using the
plus sign (see example below).
3a
Selects Terminal mode.
3b
Selects Connection mode.
4
Sets Inactivity Timeout (in 30 second increments).
6a
Sets Close on DCD loss.
6b
Enables Inactivity timeout.
7a
Sets Baud rate in bits per second.
7b
Enables DTR hang-up.
7c
Sets Flow control.
8a
Enables MUX switch on DCD loss.
8b
Sets MUX baseboard to BMC switch.
8c
Sets MUX BMC to baseboard switch.
8i
Enables Ping before MUX switch.
8j
Enables Ping.
8k
Enables Ping during callback.
8l
Sets Connection Mode settings.
14
Sets Page blackout interval in minutes.
15
Set SNMP Community string. Linux* users should
enclose the string in double quotes.
29a
Enables Terminal handshake.
29b
Enables Terminal echo.
29c
Set sTerminal delete control.
29d
Enables Terminal line edit.
29g
Sets Terminal output newline sequence.
29f
Sets Terminal input newline sequence.
Configures the serial port for server management.
Note: This command is not supported on Intel® Server Boards X38MLST, S3200SH, S55XX
and S3420GP.
Intel® System Configuration Utility – User Guide 45