Product User Guide

2.3.1 Installation on Intel

Server Board S5000XAL / S5000PAL

The Intel

Server Board S5000XAL / S5000PAL installs in rack mount 1U or 2U chassis. The

same installation steps apply to both chassis types.

• The Intel

RMM2 module ships with one plastic standoff pre-installed as shown in

Figure 2. The standoff will align with a hole in the server baseboard when mounted to

the baseboard.

• Attach the Intel

RMM2 to the connector on the server baseboard labeled “RMM”.

Snap the standoff into the corresponding hole in the baseboard.

• Next, insert three plastic standoffs into the holes of the Intel

RMM2 NIC module. See

Figure 3.

• Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle

will align.

• Mount the NIC module to the header on the baseboard and snap the three standoffs

into the corresponding holes in the baseboard. This will align the RJ-45 with the

opening in the chassis.

• Make a note of the MAC address of the Intel

RMM2. It is written on a label attached

to the module (not the NIC). Keeping a record now may eliminate the need to reopen

the cover later.

• Replace the chassis cover, attach AC power and connect a network cable to the Intel

RMM2 NIC.

AF002058

Figure 2: Installing the Intel

RMM2