Product User Guide

Intel® Remote Management Module 2 User Guide 9
2. Hardware Installations and Initial Configuration
2.1 Before You Begin
Before working with your server product, pay close attention to the Safety Information at the
beginning of this manual.
2.2 Tools and Supplies Needed
• Phillips
*
(cross head) screwdriver (#1 bit and #2 bit)
• Needle nosed pliers
• Antistatic wrist strap and conductive foam pad (recommended)
2.3 Installation
The Intel
®
Remote Management Module is currently supported on the following Intel
®
server
boards:
• All SKUs of Intel
®
Server Board S5000XAL / S5000PAL
• All SKUs of Intel
®
Server Board S5000XSL / S5000PSL
• Intel
®
Server System SC5400RA
• Intel
®
Server System S7000FC4UR
The Intel
®
RMM2 box contains the following components:
• Intel
®
Remote Management Module
• Network Interface Card (NIC) module
• Plastic bag containing screws, slot bracket, three plastic standoffs and cabling
The installation will vary between these server boards and their chassis configurations. The
following sections detail installation instructions.
Note: Remove AC power from the server before installing the Intel
®
RMM2.