Technical Product Specification

Power Sub-System Intel
®
Server Chassis H2000 Family TPS
Revision 1.0
Intel order number: G59059-001
18
The AC power cord must meet the following specification requirements:
Cable Type
SJT
Wire Size
16 AWG
Temperature Rating
105º C
Amperage Rating
13 A
Voltage Rating
125 V
Figure 11. AC Power Cord Specification
3.3 DC Ouput Specification
3.3.1 Output Power/Currents
The following table defines the minimum power and current ratings. The power supply must
meet both static and dynamic voltage regulation requirements for all conditions.
Table 19. Load Ratings for single power supply unit
Parameter
Min
Max
Peak
2,3
Unit
PSU SKU
1200W
1600W
1200W
1600W
+12V main (200-240VAC)
0.0
100
133
133
175
A
+12V main (100-127VAC)
0.0
83
83
110
110
A
+12V
STB
1
0.0
3.0
3.5
3.5
2.4
A
Notes:
1. 12V
STB
must provide 4.0A with two power supplies in parallel. The power supply fan is allowed to run in
standby mode for loads > 1.5A.
2. Peak combined power for all outputs shall not exceed 1600W (for 1200W PSU) and 2100W (for 1600W
PSU)
3. Length of time peak power can be supported is based on thermal sensor and assertion of the SMBAlert#
signal. Minimum peak power duration shall be 20 seconds without asserting the SMBAlert# signal.
3.3.2 Standby Output
The 12VSB output shall be present when an AC input greater than the power supply turn on
voltage is applied.
3.3.3 Voltage Regulation
The power supply output voltages must stay within the following voltage limits when operating at
steady state and dynamic loading conditions. These limits include the peak-peak ripple/noise.
These shall be measured at the output connectors.