System Service Guide

Hardware Installations and Updates
Installing SAS 6G solution Option 2
Replacing Node Bridge Board
1. The SAS controller module is provided as assembly with the bracket.
Figure 64. SAS Controller Assembly
2. Remove pre-installed bridge board from node tray.
3. Remove rear panel bracket. See letters A, B, C of the figure below.
Figure 65. Removing the bridge board and rear bracket
4. Align the plastic clip at the front of the board. See letter A of the figure below.
5. Plug in the bridge board to bridge slot on baseboard. See letter B of the figure below.
6. Fasten the screws located at A and C.
7. Fix the SAS controller module to bridge board and riser slot 2 on baseboard (see letters D and
E).
8. Fasten screws at F, G, and H to fix the rear bracket.
Intel
®
Server System H2000WP Family Service Guide 39