Service Guide for Intel Server System H2000WP

Hardware Installations and Updates
Intel
®
Server System H2000WP Family Service Guide 15
Installing the Front Bezel
Note: Before installing the bezel, you must install the rack handles.
1. Lock the right end of the front bezel to the rack handle (see letter A).
2. Rotate the front bezel clockwise till the left end clicks into place (see letter B).
3. Lock the bezel if needed.
Figure 20. Installing the Front Bezel
Removing and Installing the System Top Cover
Removing the System Top Cover
The server system must be operated with the system cover in place to ensure proper cooling. You will
need to remove the top cover to add or replace components (backplane, main power cables, power
distribution board) inside of the server. Before removing the top cover, power down the server and
unplug all peripheral devices and the power cable(s).
Note: A non-skid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord.
4. Remove the screws (see letter A).
5. Lift upwards from B edge (see letter B).