Monthly Specification Update

Implication The LAN driver cannot be installed with the .bat installation scripts in the driver

package.

Status The issue is fixed in the Intel

LAN driver 17.1.

Workaround Two workarounds are available:

1. Install the LAN driver manually.

2. Lower the “User Account Control” to “Never Notify”, and then install the

driver with the .bat installation scripts.

22.

Exit Air Temp reading mismatch when using IPMI command in Linux*

Problem When using IPMI command “IPMI sensor list”, the normal sensor reading is:

Exit Air Temp | 38.000 | degrees C | ok | na | 5.000 |

10.000 | 80.000 | 85.000 | na

With the IPMI command “IPMITOOL BMC reset cold”, the following error may

occur:

Exit Air Temp | 41.000 | degrees C | cr | na | 0.000 |

0.000 | 0.000 | 0.000 | na

Implication This will generate the CRITICAL entry in the SEL.

Status The issue is fixed in the BMC 1.10 release.

Workaround The error reading may not occur by the next system reboot.

23.

Intel

RAID C600 upgrade key replacement issue

Problem With the Management Engineer (ME) firmware 02.01.05.069, the server may

detect the incorrect Storage Control Unit (SCU) Redundant Array of

Inexpensive/Independend Disks (RAID) informaion after installing or replacing

the RAID upgrade key. The board or system may still show the previous RAID

information even if you have replaced the key with a new one.

Implication With the ME firmware 02.01.05.069, the system may not detect the new RAID

activation key during the first AC power on.

Status This issue is fixed with the ME firmware 02.01.05.107 and later versions.

Workaround Do a second AC power cycle to the system after the RAID upgrade key has

been installed or replaced to ensure the corrrect type of key is identified.