Technical Product Specification

Intel® Server Board S2600WP TPS BIOS Setup Interface
5.5
Loading BIOS Defaults
Different mechanisms exist for resetting the system configuration to the default values. When a
request to reset the system configuration is detected, the BIOS loads the default system
configuration values during the next POST. You can send the request to reset the system to the
defaults in the following ways:
 Pressing <F9> from within the BIOS Setup utility.
 Moving the clear system configuration jumper.
 IPMI command (Set System Boot options command)
 Int15 AX=DA209
 Choosing Load User Defaults from the Exit page of the BIOS Setup loads user set
defaults instead of the BIOS factory defaults.
The recommended steps to load the BIOS defaults are:
1. Power down the system (Do not remove AC power).
2. Move the BIOS DFLT jumper from pins 1-2 to pins 2-3.
3. Move the BIOS DFLT jumper from pins 2-3 to pins 1-2.
4. Power up the system.
Revision 1.6 Intel order number G44057-007 137