Technical Product Specification

Intel® Server Board S2600WP TPS BIOS Setup Interface
Table 47. Setup Utility – Server Management Configuration Screen Fields
Setup Item
Options
Help Text
Comments
Assert NMI on
SERR
Enabled
Disabled
On SERR, generate an NMI and log
an error.
Note: Enabled must be selected for
the Assert NMI on PERR setup
option to be visible.
This option allows the system to
generate an NMI when an SERR
occurs, which is a method Legacy
Operating System error handlers may
use instead of processing a Machine
Check.
Assert NMI on
PERR
Enabled
Disabled
On PERR, generate an NMI and log
an error.
Note: This option is only active if the
Assert NMI on SERR option is
Enabled selected.
This option allows the system to
generate an NMI when a PERR occurs,
which is a method Legacy Operating
System error handlers may use instead
of processing a Machine Check.
PCIe AER
Support
Enabled
Disabled
[Enabled] – PCIe AER (Advanced
Error Reporting) is enabled.
[Disabled] – PCIe AER is disabled.
All PCIe AER errors will be masked
after PCIe AER is disabled.
This option allows the system to monitor
and handle PCIe AER errors on PCIe
devices with PCIe AER support. But as
PCIe AER is described in PCI Express
Base Specification, any third-party
software or OS can override this BIOS
policy and take ownership of PCIe AER
handling after BIOS POST.
Log
Correctable
Errors
Enabled
Disabled
[Enabled] – Processor & PCH PCIe
correctable error logging is enabled.
[Disabled] – Processor & PCH PCIe
correctable error logging is disabled.
This option allows the system to monitor
and handle PCIe correctable errors on
PCIe devices behind Processor and
PCH.
Reset on
CATERR
Enabled
Disabled
When enabled system gets reset
upon encountering Catastrophic
Error (CATERR); when disabled
system does not get reset on
CATERR.
This option controls whether the system
will be reset when the CATERR signal
is held asserted, rather than just pulsed
to generate an SMI.
Reset on
ERR2
Enabled
Disabled
When enabled system gets reset
upon encountering ERR2 (Fatal
error); when disabled system does
not get reset on ERR2
This option controls whether the system
will be reset if the BMC’s ERR2 Monitor
times out, that is, the ERR2 signal has
been continuously asserted long
enough to indicate that the SMI Handler
is not able to service the condition.
Resume on AC
Power Loss
Stay Off
Last state
Power On
System action to take on AC power
loss recovery.
[Stay Off] – System stays off.
[Last State] – System returns to the
same state before the AC power
loss.
[Power On] – System powers on.
Clear System
Event Log
Enabled
Disabled
If enabled, clears the System Event
Log. All current entries will be lost.
Note: This option is reset to
Disabled after a reboot.
Revision 1.6 Intel order number G44057-007 117