Technical Product Specification

ManualsBrandsIntel ManualsOtherIntel Server Board S2600WP

Intel

Server System H2000WP FamilyTPS Configuration Jumpers

Steps to perform the password clear:

1. Power down server. Do not unplug the power cord.

2. Open the chassis. For instructions, refer to your server chassis documentation.

3. Move the jumper (J1F2) from the default operating position, covering pins 1 and 2, to

the password clear position, covering pins 2 and 3.

4. Close the server chassis.

5. Power up the server, wait 10 seconds or until POST completes.

6. Power down the server.

7. Open the chassis and move the jumper back to default position, covering pins 1 and 2.

8. Close the server chassis.

9. Power up the server. The password is now cleared and you can reset it by going into

the BIOS setup. The BIOS password is now cleared.

8.4 BIOS Recovery Mode (J1E1)

The Intel

Server Board S2600WP uses BIOS recovery to repair the system BIOS from flash

corruption in the main BIOS and Boot Block. This 3-pin jumper is used to reload the BIOS when

the image is suspected to be corrupted. For directions on how to recover the BIOS, refer to the

specific BIOS release notes.

Table 67. BIOS Recovery Mode Jumper

Jumper

Position

Mode of

Operation

Note

1-2

Normal

Normal mode

2-3

Recovery

BIOS in recovery mode

You can accomplish a BIOS recovery from the SATA CD and USB Mass Storage device.

Please note that this platform does not support recovery from a USB floppy.

The recovery media must contain the following files under the root directory:

1. RML.ROM

2. UEFI iFlash32 11.0 Build 2 (including iFlash32.efi and ipmi.efi)

3. *Rec.CAP

4. Startup.nsh (update accordingly to use proper *Rec.CAP file)

The BIOS starts the recovery process by first loading and booting to the recovery image file

(RML.ROM) on the root directory of the recovery media (USB disk). This process takes place

before any video or console is available. Once the system boots to this recovery image file

(FVMAIN.FV), it boots automatically into the EFI Shell to invoke the Startup.nsh script and start

the flash update application (IFlash32.efi). IFlash32.efi requires the supporting BIOS Capsule

image file (*Rec.CAP).

After the update is complete, a message displays stating, “BIOS has been updated

successfully”. This indicates the recovery process is finished.

Intel order number: G52418-006 Revision 1.6