Technical Product Specification

Power Sub-System Intel
®
Server System H2000WP Family TPS
Cable Type
SJT
Wire Size
16 AWG
Temperature Rating
105ºC
Amperage Rating
13 A
Voltage Rating
125 V
Figure 14. AC Power Cord Specification
3.3 DC Output Specification
3.3.1 Output Power/Currents
The following table defines the minimum power and current ratings. The power supply must
meet both static and dynamic voltage regulation requirements for all conditions.
Table 21. Load Ratings for single power supply unit
Parameter
Min
Max
Peak
2,3
Unit
PSU SKU
1200W
1600W
1200W
1600W
+12V main (200-240VAC) 0.0 100 133 133 175 A
+12V main (100-127VAC) 0.0 83 83 110 110 A
+12V
STB
0.0 3.0 3.5 3.5 4.0 A
Notes:
1. 12V
STB
must provide 4.0A with two power supplies in parallel. The power supply fan is allowed to run in
standby mode for loads > 1.5A.
2. Peak combined power for all outputs must not exceed 1600W (for 1200W PSU) and 2100W (for 1600W
PSU).
3. Length of time peak power can be supported is based on thermal sensor and assertion of the SMBAlert#
signal. Minimum peak power duration should be 20 seconds without asserting the SMBAlert# signal.
3.3.2 Standby Output
The 12VSB output should be present when an AC input greater than the power supply turn on
voltage is applied.
3.3.3 Voltage Regulation
The power supply output voltages must stay within the following voltage limits when operating at
steady state and dynamic loading conditions. These limits include the peak-peak ripple/noise.
These should be measured at the output connectors.
Table 22. Voltage Regulation Limits
Parameter
Min
Nom
Max
Unit
Tolerance
Intel order number: G52418-006 Revision 1.6
26