Technical Product Specification
Power Sub-System Intel
®
Server System H2000WP Family TPS
Pin
Description
Pin
Description
5 PSON# 6 12V Load Share Bus
7 SMBAlert# 8 Cold Redundancy Bus
9 Return Sense 10 PWOK
11 +12V Remote Sense 12 Compatibility Bus
13 Reserved 14 +12VSB
15 +12VSB 16 Key Pin (removed)
3.2 AC Input Specification
3.2.1 Input Voltage and Frequency
The power supply must operate within all specified limits over the following input voltage range.
Harmonic distortion of up to 10% THD must not cause the power supply to go out of specific
limits. The power supply must be capable of start-up (power-on) with full rated power load, at
line voltage as low as 90VAC.
Table 14. AC input rating.
Parameter
Min
Rated
Max
Start up VAC
Power Off VAC
110V
AC
90 V
rms
100-127 V
rms
140 V
rms
85 V
AC
±
4V
AC
70V
AC
±5V
AC
220V
AC
180 V
rms
200-240 V
rms
264 V
rms
Frequency
47 Hz
50/60 Hz
63 Hz
Notes:
1. Maximum input current at low input voltage range should be measured at 90VAC, at max load.
2. Maximum input current at high input voltage range should be measured at 180VAC, at max load.
3. This requirement is not to be used for determining agency input current markings.
3.2.2 AC input Power Factor
The power supply must meet the power factor requirements stated in the Energy Star
®
Program
Requirements for Computer Servers. These requirements are stated below.
Table 15. Typical power factor
Output power
10% load
20% load
50% load
100% load
Power factor
> 0.80
> 0.90
> 0.90
> 0.95
Note: Tested at 230Vac, 50Hz and 60Hz and 115VAC, 60Hz. Tested according to Generalized
Internal Power Supply Efficiency Testing Protocol Rev 6.4.3. This is posted
at
http://efficientpowersupplies.epri.com/methods.asp.
3.2.3 Efficiency
The following table provides the required minimum efficiency level at various loading conditions.
These are provided at three different load levels; 100%, 50%, 20%, and 10%. Output should be
loaded according to the proportional loading method defined by 80 Plus in Generalized Internal
Power Supply Efficiency Testing Protocol Rev 6.4.3. This is posted
at:
http://efficientpowersupplies.epri.com/methods.asp.
Intel order number: G52418-006 Revision 1.6
22