Service Guide

Hardware Installations and Upgrades
34 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
6. Latch the Locking Lever. Push down on the locking lever on the CLOSE 1st side (see letter A). Slide the
tip of the lever under the notch in the load plate (see letter B). Make sure the load plate tab engages
under the socket lever when fully closed. Repeat the steps to latch the locking lever on the other side (see
letter C). Latch the levers in the order as shown.
Figure 41. Installing Processor – Latch the Locking Lever
Installing Processor Heatsink(s)
1. Remove the protective film on the TIM if present.
2. Align heatsink fins to the front and back of the chassis for correct airflow (see letter A). Airflow goes from
front-to-back of chassis.
3. Each heatsink has four captive fasteners and should be tightened in a diagonal manner using the
following procedure:
i. Using a #2 Phillips* screwdriver, start with screw 1 and engage screw threads by giving it two
rotations and stop (see letter B). (Do not fully tighten.)
ii. Proceed to screw 2 and engage screw threads by giving it two rotations and stop. Similarly, engage
screws 3 and 4 (see letter C).
iii. Repeat these steps on each screw with two rotations each time until each screw is lightly tightened
up to a maximum of 8 inch-lbs torque.