Service Guide

BIOS Setup Utilities
Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide 181
Option Values: None
RTS/CTS
Help Text:
Flow control is the handshake protocol.
This setting must match the remote terminal application.
[None] - Configure for no flow control.
[RTS/CTS] - Configure for hardware flow control.
Comments: Flow control is necessary only when there is a possibility of data overrun. In that case
the Request To Send/Clear to Send (RTS/CTS) hardware handshake is a relatively conservative
protocol which can usually be configured at both ends.
When Console Redirection is set to Disabled, this option will be grayed out and unavailable.
3. Baud Rate
Option Values: 9.6k
19.2k
38.4k
57.6k
115.2k
Help Text:
Serial port transmission speed. This setting must match the remote terminal application.
Comments: In most modern Server Management applications, serial data transfer is
consolidated over an alternative faster medium like LAN, and 115.2k is the speed of choice.
When Console Redirection is set to Disabled, this option will be grayed out and unavailable.
4. Terminal Type
Option Values: PC-ANSI
VT100
VT100+
VT-UTF8
Help Text:
Character formatting used for console redirection. This setting must match the remote
terminal application.
Comments: The VT100 and VT100+ terminal emulations are essentially the same.
VT-UTF8 is a UTF8 encoding of VT100+. PC-ANSI is the native character encoding used by
PC-compatible applications and emulators.
When Console Redirection is set to Disabled, this option will be grayed out and unavailable.
5. Legacy OS Redirection