Service Guide

BIOS Setup Utilities
152 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
Option Values: Enabled
Disabled
Help Text:
Enable/Disable Onboard/IOM NIC discs Option ROM Load.
Comments: This selection is to enable/disable the discs Option ROM that is used by all Onboard
and IO Module 1 GbE and 10 GbE controllers.
This option is grayed out and not accessible if the 1 GbE or 10GbE PXE Option ROM is enabled
or if the 10 GbE FCoE Option ROM is enabled. It can co-exist with an InfiniBand* controller
Option ROM.
If the discs Option ROM is disabled, and no other Option ROM is enabled, the system cannot
perform a Network Boot and cannot respond for Wake-on-LAN.
This discs option does not appear unless there is an discs-capable NIC installed in the system as
an Onboard or IO Module NIC.
6. Onboard NIC1 Type
7. Onboard NIC2 Type
Option Values: <Onboard NIC Description>
One of these strings:
Intel
®
82574 Single-Port Gigabit Ethernet Controller
Intel
®
I350 Dual-Port Gigabit Ethernet Controller
Intel
®
I350 Quad-Port Gigabit Ethernet Controller
Intel
®
I540 Dual-Port X540 10 Gigabit RJ-45 Controller
Mellanox* ConnectX-3* Single-Port InfiniBand* FD14 Controller
Help Text: <None>
Comments: Information only. This is a display showing which NICs are available as
Network Controllers integrated into the baseboard. Each of these Onboard NICs will be followed
by a section including a group of options that are specific to the type of NIC, either as an Ethernet
controller or an InfiniBand* controller.
If a board only has one onboard NIC, the second NIC Type and following options section will not
appear. If there is an InfiniBand* controller integrated onboard, it will appear as NIC2.
For details about the NIC hardware configuration for a specific board, see the Technical Product
Specification for that board.
8. IO Module 1 Type
9. IO Module 2 Type