User Guide

Intel
®
System Configuration Utility – User Guide 33
DHCP.)
13
Selects Gateway MAC Address
14
Selects Backup Gateway IP Address
15
Selects Backup Gateway MAC Address
16
Selects Community String
C7
102
103
104
105
106
Up to a 64 byte ASCII string (printable
characters in the range 0x21 to 0x7e) DHCP
Host Name String
IPV6 Enable, use Enable or Disable to
Enable/Disable “IPV6 Enable” parameter.
Selects source for IPV6 IP Address. Values to
be used are STATIC, DHCPV6 and AUTO
Selects IPV6 IP Address for the specified
LAN channel. (This is not a valid option
when the IPV6 IP source is set to DHCPV6 or
AUTO.) format is
xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx
Selects the IPV6 Prefix Length. (This is not a
valid option when the IPV6 IP source is set
to DHCPV6 or AUTO.) Prefix length should
be from 0 to 128 as per IPv6 spec.
Selects the IPv6 Default Gateway IP. (This is
not a valid option when the IPV6 IP source
is set to DHCPV6 or AUTO.) format is
xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx.xxxx
Configures the LAN settings on a specific channel. This option is similar to /lac, but it is used
to only configure one parameter at a time. Select the parameter by choosing one of the
parameter number listed above (2a, 2b, … 16) followed by a value.
See IPMI 2.0 Specification for more information
Notes:
 The Host IP, Subnet Mask and Default Gateway IP cannot be set when DHCP is
enabled for the LAN channel.
 The Host MAC address cannot be set for any LAN channel in ESB2 BMC.
 The BMC-generated ARP responses cannot be set to “disable” on S1200BT and
S1400/S1600/S2400/S2600/S4600 platform series.
 The Gratuitous ARP is not supported on S1200BT and
S1400/S1600/S2400/S2600/S4600 platform series.
 The Gratuitous ARP interval value cannot be set on S1200BT and
S1400/S1600/S2400/S2600/S4600 platform series.
 The DHCP Host Name is common for all LAN Channels.