Specification update

Enterprise Platforms and Services Marketing Monthly Specification Update
11
Workaround None.
21.
System will boot from on-board video although install add-in video card
Problem When try to boot from add-in video card, system can not boot up.
Implication Bios video output policy by default was booting from onboard video although
install the add-in video card.
Status This issue was fixed in BIOS01.02.0009 and changed video output to installed
add-in video card by default.
Workaround Need to install internal video cable to boot up system first then disable on-
board video option in BIOS.
22.
On-board VGA cannot be set to the highest resolution (1920x1080 and
higher).
Problem The Graphics ID register in the on-board video controller is getting set
incorrectly.
Implication The video cannot be set to the highest resolutions listed here:
[1920x1080,High 256 Color, 60 Hertz]
[1920x1200,High 256 Color, 60 Hertz]
[1920x1080,High Color(16bit), 60 Hertz]
[1920x1200,High Color(16bit), 60 Hertz]
Status This issue is fixed in BMC release 1.16.4010.
Workaround None
23.
Hard drive locate LED may not instantly respond to the locate command
if backplane is connected through SAS expander to a RAID controller
Problem If backplane is connected through SAS expander to a RAID controller, the hard
drive locate LED may not instantly respond to the locate command from the
RAID controller. The LED may blink after up to 2 minutes.
Implication The symptom doesn’t happen if backplane is directly connected to the RAID
controller. Root cause has been identified in the motherboard BMC.
Status This issue may be fixed in a future BMC release.
Workaround None.