Service Guide

Hardware Installation and Upgrades
32 Intel
®
Server System R1000EP Service Guide
Figure 50. Removing the Slimline Optical Drive
4. If no device will be installed in this location, install a filler panel in this location.
Installing and Removing Intel
®
I/O Expansion Module
Installing Intel
®
I/O Expansion Module
1. Squeeze the sides of the filler panel to disengage it from the server system back panel and
remove it (see letter A).
2. Secure the screw adapter the position shown below. Position the module over the server board,
fit the front of the module into the back panel slot (see letter B).
3. Attach the module to the server board connector (see letter C).
4. Secure the module with the three screws as shown (see letter D).
Figure 51. Installing Intel
®
I/O Expansion Module