Technical Product Specification

Intel
®
Server Board S2400EP TPS Appendix A: Integration and Usage Tips
Revision 2.0 Intel order number G50763-002
119
Appendix A: Integration and Usage Tips
 When adding or removing components or peripherals from the server board, you must
remove AC power cord. With AC power plugged into the server board, 5-V standby is
still present even though the server board is powered off.
 This server board supports Intel
®
Xeon
®
Processor E5-2400 product family or Intel
®
Xeon
®
Processor E5-2400 v2 product family with a Thermal Design Power (TDP) of up
to and including 95 Watts. Previous generation Intel
®
Xeon
®
processors are not
supported.
 You must install processors in order. CPU 1 is located near the back edge of the server
board and must be populated to operate the board.
 On the back edge of the server board are EIGHT diagnostic LEDs that display a
sequence of amber POST codes during the boot process. If the server board hangs
during POST, the LEDs display the last POST event run before the hang.
 Only Registered DDR3 DIMMs (RDIMMs) and Un-buffered DDR3 DIMMs (UDIMMs) are
supported on this server board. Mixing of RDIMMs and UDIMMs is not supported.
 The Intel
®
RMM4 and I/O Module are mutually exclusive due to mechanical
limitation.DIMM Slots D1 thru F2 can only be populated in dual processor configuration.