Technical Product Specification

Power Subsystem Intel
®
Server System R1000EP Product Family TPS
18 Intel Order Number G67599-003 Revision 2.0
3.3.3 Optical Drive Power Connector
The server board includes one brown 2x3-pin power connector intended to provide power to an
optionally installed optical drive. On the server board this connector is labeled as “ODD/SSD
PWR”. The following table provides the pin-out for this connector:
Table 5. Peripheral Drive Power Connector Pin-out ("ODD/SSD PWR")
Signal Description
Pin#
Pin#
Signal Description
P12V
4
1
P5V
P3V3
5
2
P5V
GROUND
6
3
GROUND
3.4 Power Supply Module Efficiency
The following table provides the required minimum efficiency level at various loading conditions.
These are provided at three different load levels: 100%, 50% and 20%. Efficiency is tested over
an AC input voltage range of 115 VAC to 220 VAC.
Table 6. 600 Watt AC Power Supply Efficiency
Loading
100% of maximum
50% of maximum
20% of maximum
Minimum Efficiency
>=85%
>=88%
>=85%
3.5 Power Cord Specification Requirements
Power cords used must meet the specification requirements listed in the following table:
Table 7. AC Power Cord Specifications
Figure 17. AC Power Cord
3.6 AC Input Requirement
3.6.1 Power Factor
The power supply must meet the power factor requirements stated in the Energy Star
®
Program
Requirements for Computer Servers. These requirements are stated below, for all loading
conditions where the output power is greater than or equal to 75 watts.
Cable Type
SJT
Wire Size
16 AWG
Temperature Rating
105ºC
Amperage Rating
13 A
Voltage Rating
125 V