Document

Enterprise Platforms and Services Marketing Monthly Specification Update
11
Workaround None.
21.
System will boot from on-board video although install add-in video card
Problem When try to boot from add-in video card, system can not boot up.
Implication Bios video output policy by default was booting from onboard video although
install the add-in video card.
Status This issue was fixed in BIOS01.02.0009 and changed video output to installed
add-in video card by default.
Workaround Need to install internal video cable to boot up system first then disable on-
board video option in BIOS.
22.
On-board VGA cannot be set to the highest resolution (1920x1080 and
higher).
Problem The Graphics ID register in the on-board video controller is getting set
incorrectly.
Implication The video cannot be set to the highest resolutions listed here:
[1920x1080,High 256 Color, 60 Hertz]
[1920x1200,High 256 Color, 60 Hertz]
[1920x1080,High Color(16bit), 60 Hertz]
[1920x1200,High Color(16bit), 60 Hertz]
Status This issue may be fixed in a future BMC release.
Workaround None
23.
Hard drive locate LED may not instantly respond to the locate command
if backplane is connected through SAS expander to a RAID controller
Problem If backplane is connected through SAS expander to a RAID controller, the hard
drive locate LED may not instantly respond to the locate command from the
RAID controller. The LED may blink after up to 2 minutes.
Implication The symptom doesn’t happen if backplane is directly connected to the RAID
controller. Root cause has been identified in the motherboard BMC.
Status This issue may be fixed in a future BMC release.
Workaround None.