Specification Update

Monthly Specification Update
2
Summary Tables of Changes
The following tables provide an overview of known errata and known document changes that
apply to the specified Intel Server Products. The tables use the following notations:
Doc:
Intel intends to update the appropriate documentation in a future revision.
Fix:
Intel intends to fix this erratum in the future.
Fixed:
This erratum has been previously fixed.
No Fix:
There are no plans to fix this erratum.
Shaded:
This erratum is either new or has been modified from the previous specification
update.
Table 1. Errata Summary
No. Plans Description of Errata
1. Fix Linux* Operating Systems are not supported on RSTe mode
2. Fixed UEFI Microsoft Windows Server 2008* R2 SP1 installation on SCU ports may fail under RSTe RAID
mode
3. No Fix UEFI Operating System installation is not supported on ESRT2 mode
4. Fixed HDD status LEDs do not function under specific configuration
5. Fixed RSTe GUI installation may fail if there are no devices attached to any onboard AHCI ports
6. Fixed System may halt under specific BIOS configurations
7. Fixed Microsoft Windows 2003* x86 installation failure under Pass-through mode of SCU controller
8. Fixed System may halt under unsupported configuration in ESRT2 mode
9. Fixed Integrated BMC Web Console – Power Statistics page – Minimum wattage reads as zero.
10. Fixed Integrated BMC Web Console – Power Control page – Perform Action button not functional.
11. Fixed IPMI Get Chassis Status command returns incorrect Chassis Identify State.
12. Fixed The BIOS and ME Firmware can't be updated successfully using Intel
®
One Boot Flash Update
Utility (OFU) under SuSE* Linux Enterprise Server 11 (64-bit) with SP2
13. Fixed BMC continuously sends HDD assert/de-assert event during HDD RAID rebuild under ESRT2 mode
of the SCU controller
14. Fixed High CPU utilization may occur when installing or running Microsoft Windows Server 2008* R2 or
Microsoft Windows* 7 with default NIC driver for Intel
®
Gigabit ET Dual Port Server Adapter
E1G42ET and Intel
®
Gigabit ET Quad Port Server Adapter E1G44ET
15. Fixed Intel
®
LAN driver installation failure on Microsoft Windows* 7
16. Fixed Hard drives connected through SAS expander can’t be detected in legacy mode
17. Fixed On-board VGA cannot be set to the highest resolution (1920x1080 and higher)
18. Fixed Hard drive locate LED may not instantly respond to the locate command if backplane is connected
through SAS expander to a RAID controller
19. Fix Some log names in SEL are displayed incorrectly after pressing the power button to shut down
Microsoft Windows 2008* R2 64bit
20. Fix Fault LED on 4x3.5” hot swap HDD cage may not function normally during RAID rebuilding with
AHCI ESRTII RAID configuration
21. Fixed Integrated BMC Web Console – Sensor Readings Page – Memory Throttling sensor status will stay
“Critical” once triggered