Specification Update

Monthly Specification Update
9
Status This issue was fixed in BIOS 01.08.0003 and later release.
Workaround None.
17. On-board VGA cannot be set to the highest resolution (1920x1080 and
higher)
Problem The Graphics ID register in the on-board video controller is getting set
incorrectly.
Implication The video cannot be set to the highest resolutions listed here:
[1920x1080,High 256 Color, 60 Hertz]
[1920x1200,High 256 Color, 60 Hertz]
[1920x1080,High Color(16bit), 60 Hertz]
[1920x1200,High Color(16bit), 60 Hertz]
Status This issue was fixed in BMC release 1.16.4010.
Workaround None
18. Hard drive locate LED may not instantly respond to the locate command
if backplane is connected through SAS expander to a RAID controller
Problem If backplane is connected through SAS expander to a RAID controller, the hard
drive locate LED may not instantly respond to the locate command from the
RAID controller. The LED may blink after up to 2 minutes.
Implication The symptom doesn’t happen if backplane is directly connected to the RAID
controller. Root cause has been identified in the motherboard BMC.
Status This issue was fixed in BMC 01.04.2896 and later release.
Workaround None.
19. Some log names in SEL are displayed incorrectly after pressing the
power button to shut down Microsoft Windows 2008* R2 64bit
Problem If pressing power button to shut down Microsoft Windows 2008* R2 64bit, some
SEL log names are displayed as “unknown” or “N/A”.
Implication No function impact to system, only some redundant SEL logs.
Status This issue may be fixed in a future BMC release.
Workaround None.