Specification Update

Monthly Specification Update
5
4. HDD status LEDs do not function under specific configuration
Problem If drives are connected through expander to SCU ports and configured under
RSTe mode, the HDD status LEDs may not function properly.
Implication HDD status LED may not show the HDD locate, HDD fault or RAID rebuild
message.
Status This issue was fixed in RSTe driver 3.2.0.1134 and later version.
Workaround None.
5. RSTe GUI installation may fail if there are no devices attached to any
onboard AHCI ports
Problem When Microsoft Windows 2008* R2 is installed on SCU ports, the installation of
RSTe drivers and the Graphic User Interface (GUI) in Microsoft Windows 2008*
R2 will fail, if the AHCI controller is enabled while no device is attached to the
AHCI SATA ports.
Implication User may not be able to install RSTe GUI under mentioned configuration when
the AHCI controller is enabled and no devices are attached to the AHCI SATA
ports.
Status This issue was fixed in BIOS release R1.03.0002.
Workaround The workaround is to either plug a SATA device into one of the AHCI SATA
ports, or disable the onboard AHCI controller in BIOS.
6. System may halt under specific BIOS configurations
Problem Once BIOS options “EFI Optimized Boot” and “Memory Mapped I/O Above
4GB” are both enabled, and RSTe mode is selcted, system may halt during the
system POST.
Implication User may see system hang with mentioned configuration.
Status This issue is fixed in Bios release R01.03.0002.
Workaround None.
7. Microsoft Windows 2003* x86 installation failure under Pass-through
mode of SCU controller
Problem Microsoft Windows Server 2003* x86 installations on SCU RSTe pass-through
mode fail.