Service Guide

Hardware Installations and Upgrades
Intel
®
Server System R1000RP Service Guide 51
Installing the Intel
®
RMM4 NIC
Caution: Carefully remove the knock out with screwdriver; directly removing it with finger has
potential risk.
1. Attach the metal fastening bracket to Intel

RMM4 NIC module and secure the bracket with
two screws (see letter A).
2. Remove the alternate RMM4 knock out by pressing the knock out from inside of the chassis
(see letter B).
3. Connect one end of the flex cable to the RMM4 connector on the RMM4 NIC module (see
letter C).
4. Mount the NIC module to the rear panel of the chassis and secure the bracket with two screws
(see letter D).
5. Connect the opposite end of the flex cable to the RMM4 connector on the server board (see
letter E).
Figure 62. Installing the Intel
®
RMM4 NIC